All Pro Solutions HERA-6 User Manual download pdf (Page 31)

HERA LS Series CD/DVD Duplication System / User Manual

Counter:

No Counter

Preparing...

Please Wait

Loader Processing

Drive 1 <- Input Bin

Processing...

Please Wait

Follow the instructions shown in “Setting Counters” on page 18 to continue. Once

the counters have been set, press the

Enter button to confirm. You will see the

Preparing screen.

After a short interval, the robotic loader will pick the top disc from the input spindle

and place it into one of the drives. As this is happening, you will see a screen

similar to below:

This information screen shows what is happening. In this case, the loader has

taken a disc from the input spindle and is placing it into Drive 1.

The loader will continue to remove discs from the input spindle and place

those into drives until either all of the drives are full, or the count that you loaded into the counter is reached.

It takes a few seconds for the autoloader to recognize all the discs.

The system will then compare the discs in the trays to the content of the master disc residing in the Hard Drive

partition you specified. When the comparison job is complete, the autoloader will place the good discs and failed

discs into corresponding areas and you will see a PASS/FAIL result screen similar to this:

Counter Specified

No Counter Specified

PASS 16 FAIL 0

Job Completed! Press OK to

Finish

or:

Input Bin Empty (20)

Reset Hoppers?

 “PASS 16” indicates 16 discs have

been compared successfully.

 “FAIL 0” indicates none of the discs

have failed.

Press the

Enter button to finish

 “Input Bin Empty (20)” indicates that the

system has run out of discs to compare.

If you have more discs to compare, you

can empty the Output Spindle; place the

discs to be compared in the Input Spindle

and Press the

Enter button to

continue.

If you have no more discs to compare,

press the

ESC button to terminate the

operation.

5. Test + Copy

With the Test + Copy menu option, the autoloader simulates the copying process, and then makes copies if

everything works correctly. If a failure is encountered on a disc during the simulation, it will not be copied during

the copying process while the discs that passed the simulation will move on to the copying process. After the

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 61 62

Comments to this Manuals

No comments

All Pro Solutions HERA-6 User Manual Page 31

Comments to this Manuals

Related products and manuals for Media duplicators All Pro Solutions HERA-6